Wanted: Stainless steel mesh

Replies to This Discussion

Permalink Reply by Chris Banks on October 25, 2011 at 7:05pm

Hi Nic

Not really leftovers but if you get stuck I now have sheets of 316 ss mesh which I use to make False Bottoms etc - which I could cut whatever size you like from if thats any help.

Cheers

Chris

• ▶ Reply

Permalink Reply by mattd2 on October 25, 2011 at 7:47pm

Mesh or perferated sheet? How much do you charge for a false bottom for a keg?

• ▶ Reply

Permalink Reply by James P on October 25, 2011 at 8:06pm

Second that....

• ▶ Reply

Permalink Reply by Chris Banks on October 25, 2011 at 10:34pm

Sorry yeah perf sheet what dia?

• ▶ Reply

Permalink Reply by James P on October 26, 2011 at 8:19am

Hey chris, I believe 40 litre kegs are about about 400 mm dia internal. Need to check again whilst at home unless anyone else has the measurements?

• ▶ Reply

Permalink Reply by Chris Banks on October 26, 2011 at 8:30am

Thanks yeah I think you are right ~400 ish

The main thing though is what dia you can fit through the hole you have cut at the top.

• ▶ Reply

Permalink Reply by mattd2 on October 26, 2011 at 8:54am

I think the "normal" hole cut in the top is about 12" / 300 cm

• ▶ Reply

Permalink Reply by James P on October 26, 2011 at 12:12pm

Mine is only two inches less, so 300mm would work perfectly.

• ▶ Reply

Permalink Reply by Nic on October 25, 2011 at 10:40pm

Hey Chris,

How much for a 25cm square piece?

• ▶ Reply