Stainless steel tube/pipe offcuts
Hey thought I'd ask this here, proving quite hard to find on google.
I'm after 3 small lengths of stainless tube, enough to make 2 whirlpool tubes and one dip tube.
Tube size, it just needs to fit into 1/2" compression fittings.
Hit me up if you have some spare or have a good source, local or otherwise. Just want the raw tube, not a pre-made fitting.
Cheers!
Replies to This Discussion
-
Permalink Reply by Matthew Vincent on
-
Make sure you get the thin-walled stuff (0.9mm) and if the STC-1000 sensor is a tight fit, just shave the sides off with a very sharp scalpel - don't take too much off though, maybe about 1mm each side max?
-
Permalink Reply by Hamish Jones on
-
I can see me losing a finger with a scalpel, cheers for the help much appreciated
-
Permalink Reply by Karl Hayes on
-
Hi Hamish. If Tata can't help you out, gimme a shout.
-
-
will do cheers
-
-
I have a range of compression fittings that I sell. What are you after?
-
Permalink Reply by Scott H on
-
I need to make 2x whirlpool inlet/side drains to fit into 1/2 bsp sockets or elbows if needed.
So fittings and tube needed to do that.
-
-
So 1/2" Male thread to 1/2" Compression fittings in Stainless Steel? $20 each for straight and $24 each for 90'.
-
Permalink Reply by Barry on
-
I don't but for what it's worth Peter's 5/8" bender worked fine for 1/2" OD pipe.
-
Permalink Reply by Peter Smith on
-
You are welcome to try it but there is a big difference between 1/2 inch and 6mm. I would be worried if it was copper that it would collapse but the stainless seems very strong.
-
Permalink Reply by Chris Banks on
-
I have 1/4" / 6.35mm seamless tubing and a bender if required.
- ‹ Previous
- 1
- 2
- 3
- Next ›
Help Fund This Site
FRESH LIQUID YEAST!!!
DIRECT FROM THE LAB
Luke's Beer+
Events
© 2024 Created by nzbrewer.
Powered by
