Burner setup

Replies to This Discussion

Permalink Reply by JackoNZ on September 10, 2011 at 4:18pm

You can adjust those to let in more air if the flame is too yellow. They are a bit shit at best though to be honest. I have mine fully out, so opposite of what you have in your pic. Even so when I screw them back in they don't seem to do much! Good luck with it. Have a play with them until you get a nice blue flame.

• ▶ Reply

Permalink Reply by RopenutS on September 10, 2011 at 5:02pm

Oh I get ya. I didnt realise they were for that purpose. I just thought they were meant to be screwed right up so they didnt leak gas or something haha. Thanks man. Keen to fire her up!

• ▶ Reply

Permalink Reply by Michael on September 11, 2011 at 8:38am

These things are a bit shit, and I do not like mine at all. However, under Chris's advice, I also ground out the ports for each burner to get rid of all of the burrs from the cast. This also enabled more airflow, so that it burned more blue.

I cannot wait until I convert to electricity!

• ▶ Reply

Permalink Reply by Chris Mills on September 11, 2011 at 6:59am

Interesting - I'll give that try on my burner and see if it improves airflow for my setup.

• ▶ Reply