Pipe fittings - where to find?

Replies to This Discussion

Permalink Reply by denimglen on August 26, 2008 at 4:31pm

If you're using a hose braid you can cut the inside rubber pipe out but leave the nut on. You just need to find something small, right angle and semi-sharp and heat it up, stick it inside, and you can kinda melt/cut the rubber pipe out. Bit of a mission but it means you can just use the standard nut onto your nipple.

• ▶ Reply

Permalink Reply by Martin Bridges on August 26, 2008 at 10:02pm

Thanks for all the helpful suggestions. I managed to track down the remaining bits and bobs a Mitre10 Mega, so I now have a mash tun! Time to place an order for some grain and hopefully get my first all-grain batch on at the weekend!

Cheers,

Martin

• ▶ Reply

Permalink Reply by MrC on August 29, 2008 at 8:36pm

Good on ya mate. There's no going back though. My all grain beers left my extract ones for dead.

Any chance of a photo of the finished product? I'm reviewing my mash tun / lautering setup at the moment.

• ▶ Reply

Permalink Reply by Martin Bridges on August 29, 2008 at 10:59pm

Got my grain and ready to rock and roll this weekend. There will be photos. Check out my blog for details.

Cheers,

Martin

• ▶ Reply

• ‹ Previous
• 1
• 2
• Next ›
• Page