Brewtroller or BCS

Replies to This Discussion

Permalink Reply by mattd2 on September 12, 2013 at 2:15pm

All of it! Lots of questions but for starters, what flow meter did you use, is it just for cold water or mash/boil?

Cheers!

• ▶ Reply

Permalink Reply by Otto on September 12, 2013 at 2:31pm

Hi,

I used a Flow sensor similar to thishttp://www.ebay.com/itm/Flow-Meter-Sensor-beer-liquid-stock-control...

From

There are cheaper ones that are $12 and go up to 80C if you want to use it on the mash

I got the Arduino and the LCD from ebay as well.

I set the flow meter now to measure the level of the corny kegs for my brothers beer Fridge and display it on the LCD Screen

Paul

• ▶ Reply

Permalink Reply by mattd2 on September 12, 2013 at 3:11pm

Thanks Paul. much appriciated. I've got an Ardunio Mega and screen already. One project I would like to tackle is flow measurement, and then PWM control of my pump for flow control.

Cheers,

Matt

• ▶ Reply

• ‹ Previous
• 1
• 2
• Next ›
• Page