Can anyone in Palmy help me wire up a Tempmate?

Replies to This Discussion

Permalink Reply by Reece on July 23, 2012 at 7:46pm

Hey have you got the wiring diagram?

• ▶ Reply

Permalink Reply by Hillman on July 24, 2012 at 3:09pm

There's a wiring diagram here. I've actually been following these directions, and I'm pretty sure I've figured it out. My one question is the brown active wire -- the directions say to jump from power to heat and cool from the same point, but the picture shows it jumping from power to heat, and then from heat to cool. Does it make a difference?

The other question I have isn't the tempmate, but the butter conditioner. I need to take it out to fit my fermenter in the fridge. Can I just cut all the wiring, or do I need to do something with it?

• ▶ Reply

Permalink Reply by Reece on July 24, 2012 at 4:11pm

No it doesnt make a difference. The active supply is common to each relay. So you can do it either way. It looks straight forward otherwise. Any other issues just reply back.

• ▶ Reply

Permalink Reply by Hillman on July 25, 2012 at 9:32pm

Thanks. I got it working, so it's all good.

• ▶ Reply

Permalink Reply by Reece on July 25, 2012 at 9:49pm

All good any other issues you get just get hold of me I'm an automation engineer if you need help with anything

• ▶ Reply