Perforated stainless steel sheet suitable for false bottom
I have a left over piece of perforated stainless steel. It is about 500x500mm large and the perforations are 2.4mm Holes at 3.6mm Centres. I reckon you could use this for a chilly bin or a pot setup. I was hoping for $45 if you're willing to pick up from Parnell or Kohi in Auckland.
For a pot you could just cut it with snips then bolt a handle on, or do what I did and get a sheetmetal place to spot weld it.
Here is an example of the result: (this is my mash tun...not for sale of course).
Replies to This Discussion
-
Permalink Reply by Chris Coutts on
-
Cheer mate. For this one, it will be flat and extend to sides of pot, but thanks for the offer.
How do you dome them? You got a big press and some jigs?
Not sure about cost of full sheet from S&T, but the Sefar guy mentioned something about $400. I think that would be their dumb-white-guy sell price though. I got my 780x1000mm piece for $70, including some slight bargaining.
-
Permalink Reply by Liam Callaghan on
-
I don't dome them I take Mike beers and he does it - Brendan Engineering in Glenfield, top engineers and often help me out. I pay them too, some times.
- ‹ Previous
- 1
- 2
- Next ›
Help Fund This Site
FRESH LIQUID YEAST!!!
DIRECT FROM THE LAB
Luke's Beer+
Events
© 2024 Created by nzbrewer.
Powered by
