Want to place an ad email luke@realbeer.co.nz
$50+GST / month

RealBeer.co.nz

November 2011 Blog Posts (6)

My three pot brew system in one

 65lt kettle with hop back filter,internal grain basket with perf bottom,Water jacket around kettle[sparge water]Three ring gas burner with heat shields sourounding ss counterflow.A footprint of 600mm x 600mm.

,1.5m high.My design ,will post pics on completion cheers.

Added by mike on November 30, 2011 at 11:28pm — No Comments

My first all-grain brew and it's gonna be a good one (I hope)

Put down my first all-grain brew on the weekend. A version of the Yeastie Boys Digital IPA. Original recipe can be found here. Thanks Yeastie Boys!

Interpretation of it can be found here and is the one I used. Thanks Darren!

Exact recipe I used can be found…

Continue

Added by Tony Patrick on November 30, 2011 at 2:00pm — No Comments

Partial mash?steep advice...HELP

Hi a friend has given me 6 cans of malt kits, 2 Coopers lager, 2 Coopers draught and 2 Mac darks. I am now doing brew in the bag all grain brewing however I have done a steeping brew with malt added to 19 litres. Can anyone help with steeping/partial mash receipe for any of these kits with my BIAB in mind?Would like to try the lager first, open to any ideas re hops( like them all)

Added by Dave Brown on November 29, 2011 at 9:35am — No Comments

Partial mash advice

Hi a friend has given me 6 cans of malt kits, 2 Coopers lager, 2 Coopers draught and 2 Mac darks. I am now doing brew in the bag all grain brewing however I have done a steeping brew with malt added to 19 litres.

 

Can anyone help with steeping/partial mash receipe for any of these kits with my BIAB in mind?Would like to try the lager first, open to any ideas re hops( like them all)

Added by Dave Brown on November 28, 2011 at 10:10am — No Comments

Rubbermaid Orange 10 gallon round cooler

Hi - does anyone know where you can buy these in NZ?

Added by Steve Manning on November 20, 2011 at 8:17pm — 8 Comments

Breaking in my New Fermenter

Recently, I commisioned the fabrication of a new fermenter for my brewery. Several months, and several thousand dollars later - she arrived. She was in a bit of a state - and took me 3 solid days to clean out. Then I had to fabricate adapters etc so as to suit the existing hardware in my brewhouse... this took a lot of time, but I got it done within a few days.

 

So...…

Continue

Added by JoKing on November 9, 2011 at 11:30am — 20 Comments

© 2020   Created by nzbrewer.   Powered by

Badges  |  Report an Issue  |  Terms of Service