Good Chinese Supplier for Kegerator Equipment?

Replies to This Discussion

Permalink Reply by Peter Smith on November 16, 2016 at 7:13am

this guy was good, been a while since I traded aliexpress though I am looking to buy 6-8  9.5L corny kegs the postage is killing it, was perhaps going to go on holiday and then ship them back.

https://www.aliexpress.com/store/1017341?spm=2114.13010608.0.0.wsJ1DS

Dear peter smith

You have a new message from AliExpress supplier Gary Li.

Gary Li: Hi Peter,  Thanks for your order. I found you bought 8 x Male BSP quick disconnects, but most of our New Zealand customers request the NPT thread quick disconnects. Please advise.  Also, pelase confirm your registed contact information is correct.  I look forward to hearing from you.  Best regards,  Gary

• ▶ Reply

Permalink Reply by Sam DT on November 16, 2016 at 8:50am

I've ordered all my ali stuff from these guys as well - found them really good

• ▶ Reply

Permalink Reply by Cain Harland on November 16, 2016 at 11:48am

Corny kegs - brewshop seems cheapest

Regulator - These were cheaper than anything on ali when I was looking and I like it better than my old one which was what most sellers on ali are selling - http://www.trademe.co.nz/home-living/lifestyle/home-brewing/brewing...

Taps and stuff - As peter said Gary Li has good stuff at pretty good price

• ▶ Reply

Permalink Reply by Peter Smith on November 16, 2016 at 1:21pm

if you are in  no hurry and keep a cunning beady eye on trademe there are some bargains to be had regs / taps etc

• ▶ Reply

Permalink Reply by nofizznofoam on November 21, 2016 at 11:08am

Think there's still lots of Firestone kegs in Christchurch. I paid $80 plus freight 2 years ago. I can tell you all the seals you need to recondition

• ▶ Reply

Permalink Reply by Peter Smith on November 21, 2016 at 1:02pm

any of the 1/2 size 9.5L ones?

• ▶ Reply

Permalink Reply by nofizznofoam on November 21, 2016 at 1:55pm

i dont know.  mine are all 20.  apologies i missed that bit when reading earlier.

• ▶ Reply

Permalink Reply by Dave on November 21, 2016 at 4:46pm

Kegs are killed by freight, brewshop in Hamilton usually have the cheapest (usually $100 for second hand reconditioned ). Fittings definitely Ali express. Also country trading store on trademe (Australian) have stuff from China (same stuff as aliexpress) but a bit cheaper - must buy in bulk. I went through exactly this process too setting up my system! Only thing I have replaced is the taps - splashed out on Perlick flow control after hassles with cheap Chinese taps. Good luck!

• ▶ Reply