10 tip gas burner setup
I have a couple of queries on the set up of a 10 tip burner.
I've purchased a 10 tip burner from BeerBelly:
Link: http://shop.beerbelly.com.au/equipment/heating-and-cooling/heating/...
I'm planning to run it in a configuration like the image below/attached.
- Does anyone have any recommendations for sourcing brass gas fittings in Auckland? I've tried Auckland Engineering Supplies in town with no luck.
- Can anyone comment on the appropriateness of a std BBQ regulator for running a 10 tip burner? I'll be producing 50L batches (kettle is 450 diameter). Planning on using the inline brass valve to throttle back when a solid boil has been achieved, or increase the heat output for DMS cycles.
Cheers, Matt.
- Attachments:
-
-
Burner Arrangement.jpg, 1.6 MB
-
Replies to This Discussion
-
Permalink Reply by Matthew Vincent on
-
Sorry can't help with your questions - just curious how much did shipping cost?
-
-
Hi Matthew, I don't recall the shipping price, I think it was in the region of NZD75-80 landed in NZ and took close to three weeks. Interestingly, my first burner sent ended up with one of the burner tips snapped off in the post, after some negotiating I received a second burner at a good discount (shipping was uninsured). If you feel you could live with 9 tips rather than 10 then let me know as it's just gathering dust at the moment.
-
-
Re: Selling the '9-tip' burner ... How much were you thinking of?
-
Permalink Reply by Peter Smith on
-
1 Brass fittings - Mastertrade in cook st or there is a place on lunn ave just east of mitre 10 that has a bathroom showroom in front trade warehouse behind, they have brass as do the plumbing shop on quarry side... guys in town often give me trade.
2 I would think that this would be required to reach full BTU if not even bigger....
http://www.trademe.co.nz/home-living/outdoor-garden-conservatory/bb...
-
-
Cheers Peter, I'll check out mastertrade - I have heard of the place on Lunn Ave also, I just struggle to get there during opening hours.
-
Permalink Reply by IPeeAye on
-
Lots of gas fittings (brass, stainless, plastic etc) plus hoses of various descriptions at 121 Marine. 3/20 Constellation Drive, Mairangi Bay. Next to McD's
09-444 3442
http://www.121marine.co.nz
I got a fair bit of my brew fittings there!
Help Fund This Site
FRESH LIQUID YEAST!!!
DIRECT FROM THE LAB
Luke's Beer+
Events
© 2024 Created by nzbrewer.
Powered by
